11
Version 1.01
Risks associated with operations to Read or Reprogram data
When reading or programming data via K-TAG, if the communication between the tool and the
electronic control unit were to be interrupted problems may occur, also of serious entity and
which may extend to the complete failure of the ECU itself, with consequent need for its
replacement.
Therefore, during these operations:
DO NOT disconnect the communication cable between the tool and the ECU.
DO NOT unplug the USB cable between the tool and the computer.
DO NOT turn off your computer.
DO NOT use the tool in a location that is exposed to static electricity or electrical interference.
If, for any reason, a damage to the ECU or a data loss or corruption (even partial) occurs and it is
not possible to make a restoration, Alientech Srl, its subsidiaries and affiliates will not be will
not be held liable for any damages, costs or expenses coming from this loss or corruption.
Cleaning
For safety reasons, unplug the AC Power Cord from the electrical outlet and disconnect any other
cables before cleaning the product.
Cleaning the exterior surface: Wipe gently with a soft cloth. Do not use solvents or other
chemicals to clean the exterior surface of the K-TAG.
Cleaning the connectors: Do not use the product if the connectors, the AC Adaptor or the AC
Power Cord are not clean. Remove the dirt with a dry cloth.
To Next Page
Loading...