24
Version 1.01
RD: The check mark indicates whether the ECU supports the reading. If the box is white
(empty) it is not possible to read the ECU through the diagnostic connector of the vehicle.
Refer to the section File Management (page 28) for more details.
Writing is always available for all families, so there is no dedicated column.
For the OBDII mode, use the cable proposed in the Operating Manuals of the
selected Family. For the Tricore Mode, you need to use the Infineon Tricore
Module (sold separately), while for the ST mode you can use either the K4 cable or
the Infineon Tricore Module.
To Next Page
Loading...