Back to Contents Page
Display Assembly
AlienwareM18xServiceManual
Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery pack (see Removing the Battery Pack).
3. Remove the base cover (see Removing the Base Cover).
4. Remove the center control cover (see Removing the Center Control Cover).
5. Remove the keyboard (see Removing the Keyboard).
6. Remove the macro keyboard (see Removing the Macro Keyboard).
7. Using the pull-tab, pull the display cable to disconnect the display cable from the connector on the system board.
8. Disconnect and peel off the video-card connector cable from the connector on the system board.
9. Disconnect the LED-logo board cable from the connector on the system board.
10. Close the display and turn the computer over.
11. Disconnect the antenna cables from the Mini-Card (see Removing the Mini-Card).
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.