Alinco DR-CS25 - FUNCTION MENU SETUP; TALK AROUND; RADIOS DTMF SELF ID ENQUIRY; RADIOS STONE SELF ID ENQUIRY

19
7
This is to talk simplex on the RX frequency of the duplex setting, in case
of repeater failure or out-of-range.
By Talk Around function, you can directly communicate with other radios
in your group in case the repeater is not activated or when you are out of
the repeater range. The transceiver will transmit on RX frequency with its
CTCSS/DCS signaling.
Radio's 5TONE SELF ID ENQUIRY
1.
Press and hold
FUNC
key for over 2s to enter setting menu.
2.
Press
P3
/
P4
key to choose No.15
menu, LCD displays"
F--XXXXX
" ,
"
XXXXX
" is radio's 5TONE SELF ID.
3.
Press any key except
PWR
,
P3
,
P4
, , key to exit.
1.
Press and hold
FUNC
key for over 2
seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.13
menu, LCD displays "
TALK—OF
".
3.
Press / to select the desired
setting.
ON:Enable Talk Around
OFF:Disable Talk Around
4.
Press any key except
PWR
,
P3
,
P4
, , key to exit.
Radio's DTMF SELF ID ENQUIRY
1.
Press and hold
FUNC
key for over 2 seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.14
menu, LCD displays "
D--XXX
". XXX is
radio's DTMF SELF ID.
3.
Press any key except
PWR
,
P3
,
P4
, , key to exit.
Talk Around
FUNCTION MENU SETUP
beep sound
The beep provides conrmation of entry, error status or malfunctions of
the radio. You can enable or disable beep sounds.
1.
Press and hold
FUNC
key for over 2
seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.16
menu, LCD displays "
BEEP--ON
".
3.
Press / to select the
desired setting.
ON:Enable beep sounds.
OFF:Disable beep sounds.
4.
Press any key except
PWR
,
P3
,
P4
, , key to exit.
TOT (Time-out timer)
TOT prohibits the users from transmitting after a certain period of time
has elapsed. When the time is over, transmitting stops and automatically
returns to receiving. Until the PTT is released once and pressed again,
the radio will not transmit.
1.
Press and hold
FUNC
key for over 2 seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.17 menu, LCD displays "
TOT--3
".
3.
Press / to select the
desired timer setting.
Timer:1-30min,each level 1min
OFF: Disable TOT
4.
Press any key except
PWR
,
P3
,
P4
, , key to exit.