Rockwell Automation Publication 2080-UM002G-EN-E - March 2015 53
Communication Connections Chapter 5
Configure CIP Serial Driver
1. Open your Connected Components Workbench project. On the device
configuration tree, go to the Controller properties. Click Serial Port.
2. Select CIP Serial from the Driver field.
3. Specify a baud rate. Select a communication rate that all devices in your
system support. Configure all devices in the system for the same
communication rate. Default baud rate is set at 38400 bps.
4. In most cases, parity and station address should be left at default settings.
To Next Page
Loading...
