Rockwell Automation Publication 2080-UM002K-EN-E - March 2019 175
Controller Security Chapter 9
Using the memory module to copy a project to multiple controllers
You can use the memory module to download a project to multiple controllers
without connecting them to a PC with Connected Components Workbench
software installed. To do this:
1. Back up a project with “Load Always” option enabled.
2. Remove the module and plug it into a different controller.
3. Cycle the power. Observe the Status LED on the module lights up for a
few seconds while the project is being downloaded from the module to the
controller.
4. When the operation is finished you can unplug the module and leave the
slot empty, or plug in a different MEMBAK-RTC module if you want to
use the RTC functionality.
To Next Page
Loading...
Need help?
General
