Allen-Bradley Micro870

Rockwell Automation Publication 2080-UM002K-EN-E - March 2019 iii
Preface
Read this preface to familiarize yourself with the rest of the manual. It provides
information concerning:
• who should use this manual
• the purpose of this manual
• related documentation
• supporting information for Micro800® controllers
Who Should Use this
Manual
Use this manual if you are responsible for designing, installing, programming, or
troubleshooting control systems that use Micro800 controllers.
You should have a basic understanding of electrical circuitry and familiarity with
relay logic. If you do not, obtain the proper training before using this product.
Purpose of this Manual
This manual is a reference guide for Micro800 controllers, plug-in modules and
accessories. It describes the procedures you use to install, wire, and troubleshoot
your controller. This manual:
• explains how to install and wire your controllers
• gives you an overview of the Micro800 controller system
Refer to the Online Help provided with Connected Components Workbench™
software for more information on programming your Micro800 controller.
Conformal Coated Catalogs
Catalog numbers with the suffix ‘K’ are conformal coated and their specifications
are the same as non-conformal coated catalogs.
Additional Resources
These documents contain additional information concerning related Rockwell
Automation products.
Resource Description
Micro800 Expansion I/O Modules 2080-UM003
Information on features, configuration, wiring,
installation, and specifications for the Micro800
expansion I/O modules and power supply.
Micro800 Plug-in Modules 2080-UM004
Information on features, configuration,
installation, wiring, and specifications for the
Micro800 plug-in modules.
Micro800 Programmable Controllers General
Instructions 2080-RM001
Information on instruction sets for developing
programs for use in Micro800 control systems.
Micro800 Programmable Controllers: Getting
Started with Motion Control Using a Simulated
Axis 2080-QS001
Provides quickstart instructions for implementing
a motion control project in Connected
Components Workbench software.
Micro800 Programmable Controllers: Getting
Started with CIP Client Messaging 2080-QS002
Provides quickstart instructions for using CIP
GENERIC and CIP Symbolic Messaging.