Rockwell Automation Publication 2080-UM002K-EN-E - March 2019 261
Quickstarts Appendix C
Configure Controller
Password
Set, change, and clear the password on a target controller through the Connected
Components Workbench software.
Set Controller Password
In the following instructions, the Connected Components Workbench software
is connected to the Micro800 controller.
1. On the Connected Components Workbench software, open the project
for the target controller.
2. Click Connect to connect to the target controller.
On the Device Details toolbar, roll over the Secure button. The tooltip
message “Set, Change, or Clear Micro800 Controller Password
Protection” is displayed.
The following instructions are supported on Connected Components
Workbench revision 2 and Micro800 controllers with firmware revision 2.
For more information about the controller password feature on Micro800
controllers, see
Controller Security on page 167.
After creating or changing the controller password, you need to power
down the controller in order for the password to be saved.
To Next Page
Loading...
Need help?
General
