184 Rockwell Automation Publication 2080-UM002K-EN-E - March 2019
Chapter 10 Using microSD Cards
5. After the backup is completed, click OK.
The image files are stored in the default location on the microSD card
<Micro800>\USERPRJ. This location is where the controller loads from when
the Load on power up setting is configured to “Load Always” or “Load on Error”.
Alternatively, if you do not want to use Connected Components Workbench
software to create the project backup, you can also use the ConfigMeFirst.txt file.
Figure 1 - Example Configuration for Project Backup
The ConfigMeFirst.txt file also allows you to restore from the backup if you want
to configure the Load on power up setting to “Disable”.
Send image files through email
The next step is to retrieve the image files from the microSD card and send them
to your customer through email.
1. Remove the microSD card from the controller and read the card using your
computer.
2. Navigate to the location where the image files are stored (default is
<Micro800>\USERPRJ).
3. Use a compression program to zip these image files and send them to your
customer through email.
To Next Page
Loading...
Need help?
General
