EasyManuals Logo

Allen-Bradley PowerFlex 755 Reference Manual

Allen-Bradley PowerFlex 755
497 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #383 background imageLoading...
Page #383 background image
CIP Axis Attributes
Chapter 4
Rockwell Automation Publication MOTION-RM003I-EN-P - February 2018 383
ID Access Rule Signal Attribute Name
372 Set Skip Speed 3
430 Get Position Command
431 Set* Position Trim
432 Get Position Reference
433 Get Velocity Feedforward Command
436 Get Position Error
437 Get Position Integrator Output
438 Get Position Loop Output
450 Get Velocity Command
451 Set* Velocity Trim
452 Get Acceleration Feedforward Command
453 Get Velocity Reference
454 Get Velocity Feedback
455 Get Velocity Error
456 Get Velocity Integrator Output
457 Get Velocity Loop Output
480 Get Acceleration Command
481 Set* Acceleration Trim
482 Get Acceleration Reference
483 Get Acceleration Feedback
801 Get Load Observer Acceleration Estimate
802 Get Load Observer Torque Estimate
490 Get Torque Command
491 Set* Torque Trim
492 Get Torque Reference
493 Get Torque Reference - Filtered
494 Get Torque Reference - Limited
821 Get Total Inertia Estimate
520 Get Iq Current Command
521 Get Operative Current Limit
523 Get Motor Electrical Angle
524 Get Id Current Reference
525 Get Id Current Reference
840 Set Current Disturbance
527 Get Iq Current Error
528 Get Id Current Error
529 Get Iq Current Feedback
530 Get Id Current Feedback
565 Get Slip Compensation
600 Get Output Frequency

Table of Contents

Other manuals for Allen-Bradley PowerFlex 755

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allen-Bradley PowerFlex 755 and is the answer not in the manual?

Allen-Bradley PowerFlex 755 Specifications

General IconGeneral
CategoryAC Drive
Amperage2.2…1470 A
Output Voltage0 to Input Voltage
Output Current2.2…1470 A
EnclosureIP20, IP30, IP54
CommunicationsEtherNet/IP, ControlNet, DeviceNet
I/ODigital, Analog, Encoder, Relay
SafetySafe Speed Monitor
Protection FeaturesOvercurrent, Overvoltage, Undervoltage, Overload, Short Circuit, Ground Fault, Overtemperature
Operating Temperature-10°C to 50°C (14°F to 122°F)
Storage Temperature-40°C to 70°C (-40°F to 158°F)
Humidity5…95% noncondensing
AltitudeUp to 1000m (3300ft) without derating
Voltage200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Input Voltage200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Control MethodSensorless Vector

Related product manuals