Allen-Bradley PowerFlex 755 Reference Manual

CIP Axis Attributes
Chapter 4
Rockwell Automation Publication MOTION-RM003I-EN-P - February 2018 469
Bit Object CIP Axis Alarm Name
5 Feedback Battery Loss Alarm
6 Feedback Battery Low Alarm
7 Feedback Incremental Count Error Alarm
10 Control Module Overtemperature FL Alarm
12 Converter Pre Charge Overload FL Alarm
14 Excessive Current Feedback Offset Alarm
15 Regenerative Power Supply Alarm
16 PWM Frequency Reduced Alarm
17 Current Limit Reduced Alarm
18 Torque Prove Alarm
19 Decel Override Alarm
20 Preventative Maintenance Alarm
21 Motor Test Alarm
22 Hardware Configuration Alarm
23 Firmware Change Alarm
24 Converter Pre-Charge Input Deactivated Alarm
25 DC Common Bus Alarm
26 Runtime Error Alarm
27 Backplane Communication Error Alarm
28 Safety Module Communication Error Alarm
63 Product Specific Alarm
See also
Rockwell Automation Specific Exceptions on page 465
Rockwell Automation Specific CIP Axis Fault Names on page 467
Rockwell Automation Specific Initialization Faults on page 296
Rockwell Automation Specific Start Inhibits on page 455

Allen-Bradley PowerFlex 755 Specifications

General

Category	AC Drive
Amperage	2.2…1470 A
Output Voltage	0 to Input Voltage
Output Current	2.2…1470 A
Enclosure	IP20, IP30, IP54
Communications	EtherNet/IP, ControlNet, DeviceNet
I/O	Digital, Analog, Encoder, Relay
Safety	Safe Speed Monitor
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overload, Short Circuit, Ground Fault, Overtemperature
Operating Temperature	-10°C to 50°C (14°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5…95% noncondensing
Altitude	Up to 1000m (3300ft) without derating
Voltage	200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Input Voltage	200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Control Method	Sensorless Vector