EasyManuals Logo

Allen-Bradley PowerFlex 755 Reference Manual

Allen-Bradley PowerFlex 755
497 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Behavior models used in CIP Motion
Chapter 2
Rockwell Automation Publication MOTION-RM003I-EN-P - February 2018 45
Attribute Changes
A Motion Resolution or an Axis Feedback Polarity attribute has been changed and
downloaded to the controller. This can also happen during the execution of an
SSV.
Axis Feedback Changes
The feedback device has been replaced. This creates an Axis Feedback Serial
Number mismatch.
Axis Feedback Mode has changed, for example, axis with feedback changed to axis
without feedback or vice versa and downloaded to the controller.
A user program is downloaded.
A user program and tags are restored from CompactFlash card.
Manual Restore
Power up restore, when configured
Firmware is updated using ControlFLASH.
An SSV to change:
Feedback Polarity or
One of the attributes which results in a change to the Motion
Resolution attribute.
See also
APR Fault Generation on page 45
APR Fault Attributes on page 279
APR Faults can be generated:
During initial axis configuration.
During operation
When the system fails to recover the absolute position after a power cycle,
reset, or a reconnection.
APR faults are detected during these online scenarios.
Initial configuration (download)
Reconnection of the drive axis
APR Fault Generation

Table of Contents

Other manuals for Allen-Bradley PowerFlex 755

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allen-Bradley PowerFlex 755 and is the answer not in the manual?

Allen-Bradley PowerFlex 755 Specifications

General IconGeneral
CategoryAC Drive
Amperage2.2…1470 A
Output Voltage0 to Input Voltage
Output Current2.2…1470 A
EnclosureIP20, IP30, IP54
CommunicationsEtherNet/IP, ControlNet, DeviceNet
I/ODigital, Analog, Encoder, Relay
SafetySafe Speed Monitor
Protection FeaturesOvercurrent, Overvoltage, Undervoltage, Overload, Short Circuit, Ground Fault, Overtemperature
Operating Temperature-10°C to 50°C (14°F to 122°F)
Storage Temperature-40°C to 70°C (-40°F to 158°F)
Humidity5…95% noncondensing
AltitudeUp to 1000m (3300ft) without derating
Voltage200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Input Voltage200-240V AC, 380-480V AC, 500-600V AC, 690V AC
Control MethodSensorless Vector

Related product manuals