NeXGen Gilbarco/Bennett - Installation and Start Up Guide
Copyright 2018 by Allied Electronics, Inc.
October 18, 2018 Page
2-6
2. Startup and System Beep Sequence
Once the NeXGen system is powered up, the controller will beep indicating the
following events have been successful:
a. One beep- the NXG operating system is starting up.
b. Two beeps- the application software is loading.
c. Three beeps- NXG has received an IP address from the DHCP server.
2. Programming steps
a. Program the dispensers*.
b. Program the NeXGen controller via the POS**.
Note* - Dispenser programming is not within the scope of this manual.
Note** - It is not within the scope of this manual to supply complete step-by-step
POS programming instructions.
To Next Page
Loading...