Chapter 7: Powering On the Stack
88
Installing the Power Cord Retaining Clip
The power cord retaining clip that comes with the switch protects the
power cord from being accidentally unplugged from the unit.
To install the power cord retaining clip, position the “u” part facing down,
press in the sides, and insert the ends of the clip into the holes in the
retaining bracket on the AC connector on the switch. See Figure 42.
Figure 42. Installing the Retaining Clip
Go to either “Powering On the Switches Individually” on page 89 or
“Powering On the Switches Simultaneously” on page 92.
To Next Page
Loading...
