AT-GS900MX Series Installation Guide for VCStack
91
6. If there is a fourth switch, power it on and wait two minutes for it to join
the stack as a member with the ID number 4.
At this point, the stack is operational.
The ID numbers are automatically stored in special files in the flash
memories of the switches and are retained by the devices even if you
reset or power cycle the stack.
7. Secure the power cords to the switches by lowering the retaining clips.
See Figure 44.
Figure 44. Lowering the Retaining Clip
8. To continue with the installation, go to “Verifying the Stack” on
page 94.
To Next Page
Loading...
