Allworx 9224 - 4.13 Transfer

Allworx Phone Model 9224 User Guide
+1 866 ALLWORX * +1 585 421 3850 Page 19
www.allworx.com
Version: L Revised: October 11, 2018
• Quick Transfer - press one of the following PFKs:
•BLF - sends the call to the assigned extension.
• Contact - sends the call to the associated Allworx phone number.
To do an Unannounced (Blind) transfer :
1. Press the TRANSFER button. This places the current call on hold.
• Key System Mode: To transfer a call to an external party, press a free Line Appearance
PFK, and then dial the phone number.
• PBX Mode: Continue to step 2.
2. Wait for the dial tone, and then dial the number to transfer the call.
3. Hang up, press the TRANSFER button, or press the XFER soft key.
To do an Announced (Attended) transfer:
1. Press the TRANSFER button. This places the current call on hold
2. Press an unused Call or Line Appearance PFK, and dial the number of the recipient of the
transfer. Talk to the recipient.
3. Press the TRANSFER button again, and then press the PFK of the original call. This connects the
two parties.
4. Hang up the handset when finished.
To cancel the transfer, press the RELEASE button. To return to the original caller, press the held call
PFK.
To do a one-step transfer:
On an active call, the user must have a BLF, Contact, or Personal Speed Dial PFK for the recipient of the
transfer.
1. Press the BLF, Contact, or Personal Speed Dial PFK for the recipient of the transfer.
Note:
The Allworx Server Administrator may configure this method based on the phone configuration.
Note:
The Allworx Server Administrator enables the one-step transfer