Alpha-InnoTec RBE+ - Function Page Domestic Hot Water

16
Subject to change without notice | 83030100dUK | ait-deutschland GmbH
9.2.7 Function page “Domestic hot water”
1 Currently set required temperature for domestic
hot water
2 Current temperature of the hot water in the
storage tank
3 to the settings and information page “Domestic
hot water”
4 Symbol of the programme area and mode of
operation that is set
Changing the mode of operation
 “9.1.3 Making settings”, page 11, variant 2
Settings and information page
“Domestic hot water”
1 Currently set required temperature for domestic
hot water
2 Temporary demand for higher domestic hot
water temperature that is provided for a time
period set under ③
3 After the end of the set time period, the
required temperature of the domestic hot water
set under ① is supplied
4 current mode of the time programs
(inactive = off-time).
► Set the time programs on the control unit of
the heating and heat pump controller.
► ⇒ Scroll and save changes.
NOTE
High domestic hot water temperatures in the
storage tank reduce the system’s efficienc,
increase stoppage losses in the storage tank
and therefore increase running costs.
Specific national requirements must be met.
€
ENERGY SAVING TIP
Use the extra domestic hot water function (②)
to temporarily (③) increase the tapping output
(higher domestic hot water consumption).
NOTE
If off-times for the preparation of domestic hot
water are set in the heating and heat pump
controller, these are ignored for the set time
period (③) of the extra domestic hot water
function (②).