rekordbox for iOS/Android
46
En
Using Release FX of Pad FX
You need to assign a Release FX to a Performance Pad in advance.
1 Press and hold down a Performance Pad that has an effect other
than a Release FX assigned to it.
The effect turns on. The sound changes according to the type of effect and the
number of beats in the settings assigned to that pad.
2 Press the Performance Pad that has a Release FX assigned to it,
and release it.
The effect turns off, and the Release FX is added.
Using Beat Loop
If you press a Performance Pad, a loop with the number of beats
assigned to the pad is set. The loop keeps playing after you remove
your finger from the pad.
1 See: Changing pad mode (page 43) to enter Beat Loop mode.
The number of beats set to the Performance Pads are as follows:
The number displayed on each pad shows the number of beats for the loop
playback.
2 Press a Performance Pad.
The loop plays with the number of beats set on that pad.
3 Press the same Performance Pad again.
The loop is canceled and the rest of the track continues to play.
To Next Page
Loading...
