Lubricants and Glues List
Name Part No. Remarks
Lubricating oil (FLOIL G-424Z) GEM1107 Used for "9.5 CONTROL PANEL SECTION (1/3)".
Refer to "7. DISASSEMBLY".
Jig Name Part No. Purpose of use / Remarks
Software for writing the serial number
of Main unit
GGS1807 For writing the serial number of the unit to the MAIN Assy
after replacement. The file is uploaded to Niis.
Refer to "8.3 WRITING THE SERIAL NUMBER OF THE UNIT."
Crossfader calibration position setting jig GGF1731 Jig for position settings of Crossfader calibration
ISO knob setter position setting jig GGF1732 Master ISO knob center position setting jig
To Next Page
Loading...