AlphaVision ML User manual Rev. 2.60 – 01-01-2015 21
User name
For each user code, a unique user name can be programmed. Each user name can consist of up to 16
characters and is programmed with the and navigator keys.
The cursor starts underneath the letter “U”. Use the and to select the desired letter and press
to jump to the next letter and to jump to the previous letter. When the correct user name has been
entered, or when no specific user name needs to be programmed, press <#/OK> to save the user code and
all its settings.
Enrolling proximity tags on an LCD/Proximity keypad
Enrolling of proximity tags is similar to programming a new user code. To enroll proximity tags an
LCD/Proximity keypad is required. Enter the Users submenu, select the desired code number (01-90) or use
the and navigator keys and press <#/OK> to jump to the ‘code’ field. Instead of entering a code,
present your proximity tag to the integrated proximity reader, this is situated right above microphone hole.
The keypad will now automatically generate a unique 6 digit user code.
►!
When using proximity tag’s it is advised to only use 6-digit user codes !
Warning against double or conflicting user codes
From firmware V2.0 and higher the system is protected against programming double user codes. If a
existing user code is entered into a another user code location the system will not accept the code and the
code will be set back to 000000.
Duress code
The AlphaVision ML control panel also has a duress code function. The duress code function can be used to
disarm the system when under distress. The duress code option should only be used when transmitting
alarm messages to a monitoring station and only works with regular user codes and not with proximity tags.
The installer can active the duress code function. When activated, a user who is forced to disarm the system
can use his regular user code but add 1 to the last digit of his code. If the user code is 987654, the duress
code becomes 987655. If the last digit is a 9 replace it with the digit 0.
When the system is disarmed with a duress code the control panel will disarm as usual but send out a silent
duress alarm to the monitoring station.
►! When the DURESS code is used, the dialer LED will be deactivated for 15 minutes and the Information
Present will not appear. After 15 minutes, or after disarming with a valid user code, the LED’s will function as
normal and the Information Present message will reappear.
Security against random entering codes
The AlphaVision ML is secured against the random entering of user codes. After 6 consecutive invalid user
codes, all keypads are locked out for 90 seconds. After each following invalid code, the keypads will lock
again for another 90 seconds, until a valid code is entered. When the control panel is programmed to report
to a monitoring station, a special alarm message will be sent.
Telephone
The main user can program the settings used for reporting to private (fixed or mobile) telephone numbers.
Reporting to a private telephone numbers only works when a PSTN or GSM plug-on board is used and does
not work with IP or GPRS reporting. The following options can be programmed:
Telephone numbers 1 - 4
Protocol
Dial attempts
Email message (firmware version 3.2 and above)
Messages ( V3.60 and above). Here you can determine which type of messages are reported to the
relevant private telephone or mailed to the relevant email address.
To Next Page
Loading...