AlphaVision ML - Speech & Sounds

AlphaVision ML User manual Rev. 2.60 – 01-01-2015 22
In the telephone number programming option, the telephone number of a private (fixed or mobile) phone
can be programmed including area code and without using any spaces or dashes. Enter the number and
press <#/OK> to save.
Besides the standard digits 0 to 9, two special characters can be used:
w (or W) : wait 2 seconds without dial tone
- (dash) : wait until a dial tone is detected
Use the and navigator keys to select the special characters. When a character is selected, use the
to move the cursor to the next position. Always place the ‘W’ or ‘-‘in front of the telephone number.
When the correct number is entered, press <#/OK> to save.
►! By default, the control panel picks up the line and waits for a dial tone. If no dial tone is detected within
10 seconds, the control panel hangs up and tries again.
After the telephone number has been programmed, the correct protocol for this number needs to be set.
Continue to the ‘Protocol” option by pressing and selecting the Protocol option.
The Protocol option decides which type of alarm transmission is used with a certain telephone number. The
following protocols are available:
 Report spoken messages (only possible when the speech plug-on board is used)
 Report a Siren tone, this generates an alarm tone
 Report a SMS text message, this sends out an SMS text message to a (mobile) telephone
 Send an email message
Only when the AlphaVision ML control panel is equipped with a PSTN or GSM plug-on board, the siren tone
or SMS text messages can be sent to a private (mobile) telephone number.
Speech message can only be sent to private (mobile) telephone numbers when the AlphaVision ML is
equipped with a speech plug-on board.
Select one of the three options using the and keys and press <#/OK> to confirm. After setting the
protocol, the number of dial attempts needs to be set. Continue to the ‘Dial attempts’ option by pressing
and <#/OK>.
In the dial attempts programming you decide how many times the AlphaVision ML control panel will try to
reach each private telephone number. The number of dial attempts can be programmed from 1-9 or DO
NOT CALL. When the option DO NOT CALL is selected, this telephone number will be skipped. The number
of dial attempts is programmed using the and keys and is saved using the <#/OK> key.
In Email recipient an email address can be entered for up to four warning addresses. To send an email as
alarm or status message some additional basic settings are needed. Your installer will program this
information in the installer menu.
Speech & Sounds
The Speech & Sounds submenu contains the following options:
 Change volume
 Speech option
 Doorbell option
►! These options only apply when the AlphaVision ML control panel is equipped with a speech plug-on
board including a keypad with integrated speakers, an external speakerphone or an external
speaker.