AlphaVision ML User manual Rev. 2.60 – 01-01-2015 25
The installation company might ask you to initiate the Remote Service connection. This starts up an IP
connection between the AlphaVision ML control panel and the service computer of the installation
company. The installation company will guide you through the possible options: Remote Service, Port
Settings, IP address settings.
►! Even though the Remote Service function does not allow the installation company to arm or disarm
the system or create or edit user codes, the Remote Service function does allow changing of system
settings. Take appropriate measures and make clear agreements with your installation company to
prevent unauthorized access.
Installer access
The supervisor can use this option to determine whether the installer has direct access to the installer menu
or access is only possible via the user menu.
Transmit testmessage
The supervisor has the option to manually force the panel to send a testmessage to the monitoring station.
Your installer may request you to perform this option.
Access via App
From software V2.03 a mobile application (APP) is available for the Alpha Vision ML. The supervisor must
indicate whether the APP has permission to connect to the Alpha Vision ML. Use the and
navigator keys to choose between the options: ACCESS or NO ACCESS. Make a selection and press <#/OK>
to confirm the selection.
App key
A part of the mobile application (APP) is a unique key. This key needs to be entered both in the AlphaVision
ML and the mobile application (APP). The key is checked when establishing a connection. When entering
the APP key the and navigator keys can be used to programmed the desired letters, numbers or
special symbols. Press the key to jump to the next position. If the APP key only consists of numbers
these may be entered using the numerical keys on the keypad. Press the <#/OK> button to store the APP
key.
Bypassing zones
From firmware V3.2 and above it is possible to bypass (block) zones prior to arming the system. This
functionality can be very useful if a zone is faulty or a continuous false alarm occurs preventing the system
from being armed. By bypassing (temporarily blocking) the zone the alarm system can be armed, the
bypassed zone is not active and cannot generate an alarm. Bypassing a zone applies only to one arming
period, once the system is disarmed the bypassing is automatically erased. If the zones needs to be
bypassed again, a bypass function must be performed again before arming.
To bypass a zone in advance select the "Bypass" option in the user menu. Now enter the desired zone
number (2-digit) or use the a the and keys to scroll to the desired zone number. Now press the
<#/OK> key to confirm the bypass function.
Historic Log
The supervisor can also access the historic log. The historic log shows the last 250 event. The top line in the
display shows the event type and the bottom line shows the date and time. Use the navigator keys to scroll
through the events.
To Next Page
Loading...