Alpine CDA-137EBT User Manual

Listening to Radio
1
7
•
•
•
Note
2
4
3
Press SOURCE/
C
to select TUNER mode.
Press and hold SETUP for at least 2 seconds to return to
normal mode.
Pressing
c
returns to the previous SETUP mode.
If no operation is performed for 60 seconds, SETUP is cancelled.
To synchronize the clock to another clock/watch or radio time
announcement, press and hold
s
/ENTER
for at least 2 seconds aer
setting the "hour". Minutes will reset to 00. If the display shows over "30"
minutes when you do this, the time will advance one hour.
Press BAND repeatedly until the desired radio band is
displayed.
F1 (FM1)
d
F2 (FM2)
d
AM
d
F1 (FM1)
Press
w
or
e
to tune in the desired station.
Holding down
w
or
e
will change the frequency
continuously.
Press TUNE/A.ME to select the tuning mode.
DX (Distance mode)
d
LOCAL (Local mode)
d
MANUAL (Manual
mode)
d
DX (Distance mode)
Note
• e initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
Radio
Presetting Stations Manually
Tune in the station you want to store. Press and hold, for at
least 2 seconds, any one of the preset buttons (1 through 6)
into which you wish to store the station.
The display shows the band, preset number and station frequency
memorized.
Adjusting Volume
Turn the Rotary encoder until the desired sound is obtained.
Setting the Time and Calendar
1
2
3
Press and hold SETUP for at least 2 seconds to activate the
SETUP selection mode.
Turn the Rotary encoder to select General, and then press
s
/ENTER.
Bluetooth
s
General
s
Display
s
Tuner
s
USB
s
Bluetooth
Turn the Rotary encoder to select Clock Adjust, and then
press
s
/ENTER.
4
5
Turn the Rotary encoder to set year.
Press
s
/ENTER.
6
Repeat steps 4 and 5 above to set month, date, hour and
minute.
2
3
Press (OPEN) to open the front panel, and then remove
it.
Press RESET with a ballpoint pen or similar pointed object.


SOURCE/

TUNE/A.ME
BAND
/ENTER

Rotary encoder
Preset buttons
(1 through 6)
•
•
Note
A total of 18 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2 and AM).
If you store a station in a preset memory which already has a station, the
current station will be cleared and replaced with the new station.

RESET switch
8
-EN

Alpine CDA-137EBT Specifications

General

Brand	Alpine
Model	CDA-137EBT
Category	Car Receiver
Language	English