IMPRINT Operation
(optional)
Note
•
When the Text Scroll is set to Manual, press and hold
VIEW
for at least 2
seconds, the current text will be scrolled one time.
Displaying the Text
You can display the tag information of a song in the iPod/iPhone.
Press VIEW.
Each press changes the display.
*3
*3
Track No./All Songs No.
*2
(Blank)
Elapsed Time
(Blank)
Calendar
Artist Name
*1
Song Name
*1
Clock
Track No./All Songs No.
*2
Album Name
*1
Song Name
*1
Elapsed Time
*1
*2
*3
TAG information
If the Text Scroll (refer to “Scroll Setting (Text Scroll)” on page 20)
is set to “Auto,” the tag information will scroll automatically.
If there is no text information, nothing will be displayed.
e numbers of all songs displayed vary depending on the songs
selected by the search.
When the Text Scroll (refer to “Scroll Setting (Text Scroll)” on
page 20) is set to “Auto,” the display cannot be switched by pressing
VIEW
. e display contents switch alternately.
Note
•
•
•
•
Only alphanumeric characters (ASCII) can be displayed.
e maximum number of characters for the head unit is 128 (128 byte).
Some characters may not be correctly displayed.
e display is blank when text information is not compatible with this
unit.
Alpine introduces IMPRINT - the world’s rst technology that
thoroughly eliminates in-car acoustic problems that normally degrade
sound quality, which enables us to experience music the way the artist
intended.
When the IMPRINT audio processor (PXA-H100) (sold separately) is
connected to this unit, MultEQ and the following sound adjustment can
be performed.
MultEQ, developed by Audyssey Labs, automatically corrects the
audio for the listening environment. e system is optimized for
selected positions in the vehicle. To accomplish this, MultEQ must take
measurements of the vehicles response characteristics. For details on the
set up procedure, consult your authorized Alpine dealer.
Changing MultEQ mode
1
2
3
Press and hold SOUND SETUP for at Least 2 seconds to
activate the Sound menu selection mode.
Turn the Rotary encoder to select MultEQ Mode, and then
press
s
/ENTER
.
Turn the Rotary encoder to select the desired MultEQ mode,
and then press
s
/ENTER.
OFF (Manual Mode)
s
Curve 1 (MultEQ-1)
s
Curve 2 (MultEQ-2)
Note
•
•
•
e Curve mode can be selected only when Curve 1 and Curve 2 are
stored.
When using MultEQ, MX, X-Over, T.Correction, Factory's EQ, SUBW.
Phase, SUBW. Channel, TW Setup, EQ Mode, Filter Type and Parametric
EQ/Graphic EQ are set automatically. ey are no longer user adjustable.
When an external audio processor is connected, the MultEQ function
cannot be used.
33
-EN
Preset buttons
(1 through 6)
SOURCE/
BAND
Rotary encoder
/ENTER
AUDIO/SOUND SETUP
To Next Page
Loading...
Need help?
General
