Alpine CDA-137EBT User Manual

Remove the iPod/iPhone
Connect USB Memory
Remove USB Memory
Remove the iPod/iPhone from Interface cable for iPod.
Connect the USB cable to the USB connector of the unit, and then
secure the connection using the lock case supplied with USB cable as
shown below.
Pull out USB Memory squarely from the USB cable.
Note
•
•
•
Aer changing the unit to a source other than the USB iPod, remove the
iPod/iPhone. If the iPod/iPhone is removed in the USB iPod mode, data
may cause damage.
If sound is not output or the iPod/iPhone is not recognized even when
the iPod/iPhone is connected, remove the iPod/iPhone once, then
connect it again, or reset the iPod.
Do not leave the iPod/iPhone in a vehicle for a long time. Heat and
humidity may damage the iPod/iPhone and you may not be able to play
it again.
USB Memory Connection (sold separately)
Note
•
•
•
•
When removing USB Memory, pull it out straight..
Route the USB cable away from another cables.
If sound is not output or USB Memory is not recognized even when USB
Memory is connected, remove USB Memory once, then connect it again.
Change to a source other than the USB Memory mode, then remove the
USB Memory. If the USB Memory is removed in the USB Memory mode,
data may be damaged.
49
-EN
This unit
USB Memory
(sold separately)
lock case
Cable (Supplied)
USB Connector
This unit
USB Memory
(sold separately)
USB Connector
Cable (Supplied)
Mounting the Microphone
For the sake of safety, mount the microphone in the following location.
Choose a location for the microphone that can easily pick up the
driver’s voice. Requiring the driver to move towards the microphone for
audibility causes a distraction that could be dangerous.
•
•
•
In a stable and secure location.
In a location that does not inhibit safely driving the vehicle.
Mount the microphone in a location where the driver’s voice can
easily be picked up.

Alpine CDA-137EBT Specifications

General

Brand	Alpine
Model	CDA-137EBT
Category	Car Receiver
Language	English