Alpine CDA-137EBT User Manual

e
f
g
q
Button
Press this button to switch between the Play and Pause
modes for CD.
Audio Processor Button
Each press of the button changes the audio processor
mode. For details, refer to "Operating the Audio Processor"
as shown below. Press the button to activate the external
audio processor mode when the external audio processor is
connected.*
Power Button
Press this button to turn the power on/o.
*
For the operation of external audio processor, refer to the Owner's
Manual of the external audio processor you purchased. When
the IMPRINT audio processor (PXA-H100) (sold separately) is
connected, refer to "IMPRINT Operation (optional)" on page 33.
Band Button
d
UP Button
u
Button
h
i
j
Radio mode:
BAND Button.
Press this button and the band will change.
Radio mode:
SEEK (UP) button
Radio mode:
Pressing this button will select, in descending order,
stations programmed into the radio's presets as shown
below.
Changer mode:
To switch the changer.
CD/iPod mode:
Press this button to advance to the beginning of the next
track.
CD Changer mode:
DISC Select (DN) button.
Press this button to select a disc in descending order.
MP3/WMA/AAC mode:
Folder Select (DN) button.
Press this button to select the folder.
MP3 compatible CD changer mode:
Folder Select (DN) / DISC Select (DN) button. Press this
button to select a folder in descending order. Press and
hold this button to select a disc in descending order.
iPod mode:
Switches Playlist/Artist/Album/Genre/Composer.
Mute Button
Press this button to lower the volume by 20 dB instantly.
Press this button again to cancel.
   ...   
k
Operating the Audio Processor
1
2
Press A.PROC to select the mode.
Normal mode
d
Time Correction
d
X-OVER
d
Normal mode
Press
i
or
u
to select the item.
Time Correction mode/Crossover (X-OVER) mode:
Select from MEMORY 1 through 6.
Applicable battery: Use two "AAA" sized dry batteries or equivalent.
Battery Replacement
1
2
3
Opening the battery cover
Slide out the battery cover while rmly pressing in the direction of the
arrow.
Replacing the battery
Insert the batteries, observing the polarities as illustrated.
Closing the cover
Slide the cover as illustrated until a click is heard.
Point the remote control transmitter at the remote control sensor.
Controllable With Remote Control
Remote control sensor
42
-EN

Alpine CDA-137EBT Specifications

General

Brand	Alpine
Model	CDA-137EBT
Category	Car Receiver
Language	English