EasyManuals Logo

Alpine CDA-137EBT User Manual

Alpine CDA-137EBT
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Presetting Stations Automatically
Tuning to Preset Stations
1
2
Press BAND repeatedly until the desired radio band is
displayed.
Press and hold TUNE/A.ME for at least 2 seconds.
The frequency on the display continues to change while
the automatic memory is in progress. The tuner will
automatically seek and store 6 strong stations in the
selected band. They will be stored into preset buttons 1 to
6 in order of signal strength. When the automatic memory
has been completed, the tuner goes to the station stored in
preset location No.1.
Select the desired band, then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of the
station selected.
Note
If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Frequency Search Function
1
2
3
Press
s
/ENTER in Radio mode to activate Frequency
search mode.
You can search for a radio station by its frequency.
Turn the Rotary encoder to select the desired frequency.
Press
s
/ENTER to receive the selected frequency.
Note
Press
c
in the search mode to cancel. Or, the search mode will be
cancelled if no operation is performed for 10 seconds.
Playback
1
3
2
4
5
6
Press
(OPEN)
The front panel will open.
While playing back MP3/WMA/AAC, press 1
o
or
p
2 to select
the desired folder.
Pressing and holding
1
o
or
p
2
will change folders continuously.
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Press
w
or
e
to select the desired track (le).
Pressing and holding
w
or
e
will fast backward/fast
forward track continuously.
To pause playback, press
q
.
Pressing
q
again will resume playback.
After pressing
(OPEN) to open the front panel, press
v
to
eject the disc.
Note
Note
Do not remove a CD during its eject cycle. Do not load more than one
disc at a time. A malfunction may result from doing either.
When a disc is already inserted, press
SOURCE/
a
to switch to the DISC
mode.
CD/MP3/WMA/AAC
ree-inch (8 cm) CDs can not be used.
Any le protected by DRM (Digital Rights Management) copy protection,
cannot be played back on this unit.
e track display for MP3/WMA/AAC data playback is the le numbers
recorded on the disc.
e playback time may not be correctly displayed when a VBR (Variable
Bit Rate) recorded le is played back.
Press
VIEW
to switch the display. For details, refer to "Displaying the
Text" on page 16.
9
-EN
VIEW
1
2
4 5
SOURCE/
/ II
/ENTER
Rotary encoder

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alpine CDA-137EBT and is the answer not in the manual?

Alpine CDA-137EBT Specifications

General IconGeneral
BrandAlpine
ModelCDA-137EBT
CategoryCar Receiver
LanguageEnglish

Related product manuals