HYC_50 – Operation and Installation Guide
Hardware
Version 1-2
All rights reserved. Reproduction of this document, in whole or in part, is only permitted with the permission of alpitronic GmbH.
1. Safety instructions
This chapter contains the safety instructions that must be observed when installing,
operating and maintaining the HYC_50 rapid charging system for electric vehicles. Improper
operation due to non-observance of the operating instructions can lead to serious injuries or
damage. These safety instructions must be read carefully before installing, operating and
maintaining the unit.
1.1. Intended use
The HYC_50 rapid charging system for electric vehicles is intended for indoor and outdoor
use to carry out rapid charging processes for electric vehicles.
Attention
The DC charging station is designed for fixed installation with
attachment to the wall or with optional stand on the floor in an
environment with a pollution degree class 4 and intended for locations
with unrestricted access (operation by laymen).
The DC supply device for electric vehicles is supplied from an AC/ three-
phase network and supports charging mode 4 (protection class I).
For the connection between the charging station (Electric Vehicle
Supply Equipment, EVSE) and the electric vehicle (EV), no other DC
cables are required apart from those supplied with the HYC_50. The
charging cable must not be modified to extend or shorten the cable
range.
Do not use adapters that are not approved by the vehicle manufacturer.
The use of Y-cables or similar devices is not permitted.
1.2. User
These operating and installation instructions are intended for people who are responsible
for the installation, operation, maintenance and servicing of the HYC_50 rapid charging
system for electric vehicles. These people should have at least a basic knowledge of high-
power electrical systems and electric vehicles. Before carrying out any work, these
instructions must be read carefully by both the operator and the technical personnel in
charge.
To Next Page
Loading...
Need help?
General
