Settings P54x/EN ST/La4
MiCOM P543, P544, P545, P546
(ST) 4-41
ST
1.3.14 Thermal overload
The thermal overload function within the MiCOM P54x is capable of being selected as a
single time constant or dual time constant char on the type of plant to
b
acteristic, dependent
e protected.
Setting range
Menu text Default setting
Min. Max.
Step size
Characteristic Single Disabled, Sing l le or Dua
Setting for the operating characteristic of the thermal overload element.
Thermal Trip
1 x n 0.08 x n 4 x n 0.01 x n
Sets the maximum full load current allowed and the pick-up threshold of the therma
characteristic.
l
Thermal Alarm 70% 50% 100% 1%
Setting for the thermal state threshold corresponding to a percentage o
at which an alarm will be generated.
f the trip threshold
Time Constant 1 10 minutes 1 minute 200 minutes 1 minute
Setting for the thermal time constant for a singl irst e time constant characteristic or the f
time constant for the dual time constant characteristic.
Time Constant 2 5 minutes 1 minute 200 minutes 1 minute
Setting for the second thermal time constant for the dual time constant characteristic.
1.3.15 V
U
i
oltage protection
nder and overvoltage protection included within the MiCOM P54x consists of two
ndependent stages. The measuring mode
(ph-N or ph-ph) and operating mode (any phase
o gurable as a combination between Stage 1 and Stage 2, therefore
a ependent operation for each stage.
S lected MT, DT or Disab thin the V<1 function cell. Stage 2 is
D
Two re required.
nge
r 3 phase) are confi
llowing completely ind
tage 1 may be se as ID led, wi
T only and is enabled/disabled in the V<2 status cell.
stages are included to provide both alarm and trip stages, whe
Setting ra
Menu text Default setting
Min. Max.
Step size
UNDERVOLTAGE
V< Measur't. Mode V<1 & V<2 Ph-Ph
V<1 & V<2 Ph-Ph
V<1 & V<2 Ph-N
V<1Ph-Ph V<2Ph-N
V<1Ph-N V<2Ph-Ph
N/A
Sets the combination of sured input voltage that will be us the unde e
ing will
visible but will not affect the ope e sta is enab
mea ed for rvoltag
elements.
Note: If any stage is disabled, the associated text in the setting menu cell sett
remain ration of th ge that led.
V< Operate Mode
V<1 & V<2 Any Ph
V<1 & V<2 Any Ph
V<1 & V<2 3Phase
V<1AnyPh V<2 3Ph
V<1 3Ph V<2AnyPh
N/A
Setting that determines whether any phase or all three phases has to satisfy the
undervoltage criteria before a decision is made.
Note: If any stage is disabled, the associated text in the setting menu cell setting will
remain visible but will not affect the operation of the stage that is enabled.
To Next Page
Loading...
