11 | P a g e
© Copyright 2012 Altech UEC (Pty) Ltd
4 INSTALLING AND CONNECTING THE PVR
4.1 QUICK START GUIDE FOR EXISTING AURORA
INSTALLATIONS
4.1.1 Remove decoder from packaging.
4.1.2 Insert supplied batteries into the remote control.
4.1.3 Connect to existing TV and satellite dish to the back of the PVR.
4.1.4 Power up the PVR and wait while the PVR starts up.
4.1.5 If the PVR does not scan first time, Press help & follow installation prompts to
change LNB settings.
4.1.6 PVR should lock to service and present video.
4.2 LOOP THROUGH CONNECTION:
4.2.1 Connect the Loop through F-F connector on LNB1 out to LNB 2
in –see the below picture
To Next Page
Loading...
General