Alto-Shaam Vector Series - Updating the Interface Board (IB)

OPERATION
Vector™ H Serie s ▪ S ervice M an ual ▪ MN-4 6 543 ▪ R ev 01 ▪ 11/ 1 9
12
How to Update the Interface Board (IB)
Before you begin ▪ The chambers should be off (not preheated).
▪ Do not remove the USB drive during the update process.
▪ You will need a USB drive with the updated firmware.
▪ You will need to know the service pass code.
Procedure To update the interface board, do the following.
Step Action
1. Touch the gear icon a. The User Configuration screen displays.
2. Touch the USB icon b. The USB Functions screen displays.
3. Plug the USB drive into the port c.
Continued on next page
NOTICE
Do not remove the USB drive during the update
process.
B
acon
Fr
e
n
c
h
toas
t
Fried e
ggs
Bi
scu
i
ts
Coo
ki
e
s
Ready to Cook
P
r
e
h
ea
t
Lin
M
a
n
ua
l
Pro
g
ra
m
[
[
[
[
[
[
[
[
O
F
F
O
F
F
O
F
F
O
F
F
Time
RecipesLogsUSB
Service Sounds
User Configuration
VMC-TS-007669
a
Tim
e
R
ecip
e
s
Lo
gs
U
ser Confi
g
uratio
n
Update IB
H4-XX.XX
Load
Config
Save
Logs
Save
Recipes
Update CB
Ver X.X
Load
Recipes
USB Functions
VMC-TS-007849
b
VMC-TS-007852
c