18 SCRUBTEC R 361 - R 366 - R 371 - R 371 C 9097421000(1)2008-01 A
ENGLISH USER MANUAL
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Centre.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can
be consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Squeegee cleaning
Brush cleaning
Tank and vacuum grid with float cleaning
Battery charging
Squeegee blade check and replacement
Side skirt check
Solution filter cleaning
Battery (WET) fluid level check
Screw and nut tightening check (1)
Check and adjustment of driving belts between motors and
cylindrical brushes
(2)
Squeegee cable sliding shoe lubrication (2)
Electromagnetic brake efficiency check (2)
Brush/pad-holder motor carbon brush check or replacement (2)
Vacuum system motor carbon brush check or replacement (2)
Drive system motor carbon brush check or replacement (2)
(1) And after the first 8 working hours.
(2) This maintenance procedure must be performed by Alto authorised Service Center.
MACHINE WORKING HOUR CHECK
Insert the ignition key (41) and turn it to “I”.
In the first 5 seconds of machine operation, the display (38) shows the total number of working hours (scrubbing/drying) per-
formed by the machine.
Turn the ignition key (41) to “0”.
1.
2.
To Next Page
Loading...
Need help?
General
