28
Removing Storage Drawer
1. Slide drawer out until it stops.
2. Grasp drawer sides near back of drawer.
3. Lift up and out.
• Reverse to reinstall.
Replacing Burner Caps
To replace burner caps after cleaning, make sure cap is
dry, properly aligned, and leveled. Pegs in the burner body
fit into recess in underside of burner cap. Burner cap must
be correctly seated on burner body for proper operation of
burner. Burner will not burn properly if wrong size burner
cap is placed on wrong size burner body. Check for
ignition after placement.
Burner cap
Burner body
Replacing Drip Pans
Drip pans may be removed for cleaning. When replacing
drip pans after cleaning, holes in drip pan must match
properly with burners. Drip pans will fit properly only one
way.
Problem Check
Oven light not
workin
Check for loose bulb.
Check for burned out bulb; replace
with 40 watt appliance bulb.
Oven not
heating
Turn on surface burners to confirm
gas is supplied to range. Confirm
range is plugged in and circuit
breaker is not tripped.
Oven door will
not open
Wait for oven to cool. Door latch will
release automatically.
Ran
e top
gets warm
during use
This is normal.
Oven
temperature is
not accurate
Store bought oven thermometers do
not measure oven temperature
accurately. An accurate di
ital
thermometer is necessary to calibrate
oven.
Check for blocked heat vents.
Aluminum foil alters oven
temperature.
Confirm correct utensil is used for
cooking.
Oven cycles
on and off
This is normal when baking or
roastin
.
Self-clean
cycle not
workin
Confirm oven door is closed.
Surface
burner not
li
htin
Confirm cap is properly placed. Verify
drip pan is properly positioned in pan
section. See “Care and Cleanin
”
section.
Before Calling for Service
To Next Page
Loading...
Need help?
General
