Amazon AMALOG+ - Page 22

To Next Page

To Previous Page

Settings

AMALOG BAH0017.1 11.08

Activate the functions of the on-board computer

Code 1 Activate all functions of the on-board computer

Mode 1

Code 2 Activate only the hectare counter of the on-board computer

Number of track marker sensors

Code 0

Machines with 2 track marker sensors,

e.g. front tank drill combination

with 2 track marker sensors (see Fig. 16).

Code 1

Machines with 1 track marker sensor

• on hydraulic valve (see Fig. 17)

• on control mechanism (see Fig. 18).

Mode 2

Code

2 to 99

Machines without track marker and

without track marker sensors [see note Fig. 19, on page 23)].

Machine type

Code 0 Cam wheel seed drill

Code 1 Pneumatic seed drill

Mode 3

Code 2 Direct seed drill Primera

The period between occurrence of the error in tramline control and triggering of the

alarm.

Code 00 Alarm switched off (factory setting)

Code 10 Setting for pneumatic seed drills (10 seconds)

Mode 4

Code 22 Setting for cam wheel seed drills (22 seconds)

The period in which no alarm must be triggered

• for cam wheel seed drills

between the command to create tramlines and standstill of the lay shaft

• for pneum. seed drills

between the command to create tramlines closing of the outlets in the distributor

head.

Code 00 Do not make this setting (0 seconds)

Code 10 Setting for pneumatic seed drills (10 seconds)

Mode 5

Code 22 Setting for cam wheel seed drills (22 seconds)

Rotary cultivator monitoring

Code 0 Setting without rotary cultivator monitoring

Modus 6

Code 1 Setting with rotary cultivator monitoring

Fig. 15

Main Page

Amazon AMALOG+ - Page 22

Table of Contents