Settings
AMALOG BAH0017.1 11.08
23
Seed drill with two track marker sensors (Fig.
16/1).
Fig. 16
Seed drill with
one track marker sensor (Fig. 17/1) on hydraulic
valve.
Fig. 17
Seed drill with one track marker sensor (Fig.
18/1) on control mechanism.
Fig. 18
Note on mode 2, Code 2 to 99 [see (Fig. 15), on page 22]
For seed drills without track marker and without track marker sen-
sors, the figures 2 to 99 correspond to the time (seconds) between
stopping (standstill of gearbox) and continued counting of the tram-
line counter.
For seed drills without track marker sensor, the tramline counter
shifts on as soon as the set time expires after gearbox standstill, e.g.
after the seed drill is raised for turning at the end of the field.
In event of a brief pause within the set time, the tramline counter
does not continue to count.
Fig. 19
To Next Page
Loading...