Super SMARTCUT BAF0009.3 05.17
Caution:
When you intend to work on the rotor with the hopper raised,
make sure that the rotor is stationary and engage the retaining
hook on the container.
6.2 Mowing
The cutting tools described above are used for mowing or scarifying.
The working speed depends on the density and wetness of the turf. It
must be adjusted to suit the conditions. The maximum PTO shaft
speed of 540 rpm must be observed. The hopper must be emptied in
good time to ensure tidy collection. If the container is too full, this may
cause a blockage in the vertical shaft above the rotor that does not
dislodge when the container is emptied.
The hopper is fitted with an indicator that shows whether the con
needs to be emptied (Fig. 6.2).
While the indicator is in the lower position, cuttings can continue to be
collected. When the pointer starts to approach or has reached the
upper position, the hopper must be emptied. The sensitivity of the
indicator is dependent on the type of the cuttings.
To Next Page
Loading...
Need help?
General
