Adjusting the cutting height
GH HH Super SMARTCUT BAF0009.3 05.17
7 Adjusting the cutting height
The cutting height of the Groundkeeper / HorseHopper Super can be
adjusted via the front guide wheels and rear cage roller.
The height of the guide wheels is adjusted by removing and reposi-
tioning the distance sleeves (fig. 7-1). To adjust the wheels, it is nec-
essary to raise the machine using the tractor's hydraulic system. The
lynch pins must be removed and the sleeves positioned according to
the required working height. Then hook the lynch pin back in and se-
cure.
The height of the rear cage roller is adjusted as follows:
• Raise the machine.
• Loosen the clamping screw (fig. 7-2),
To Next Page
Loading...
Need help?
General
