Ambient Weather WS-5000 User Manual

Version 1.10 ©Copyright 2020, Ambient LLC. All Rights Reserved. Page 50
http://www.ambientweather.com/stprraga.html
Make sure you periodically clean the rain gauge funnel.
Note: The purpose of calibration is to fine tune or correct for any sensor error associated with the devices margin
of error. Errors can occur due to electronic variation (example, the temperature sensor is a resistive thermal device or
RTD, the humidity sensor is a capacitance device), mechanical variation, or degradation (wearing of moving parts,
contamination of sensors).
Calibration is only useful if you have a known calibrated source you can compare it against and is optional. This
section discusses practices, procedures and sources for sensor calibration to reduce manufacturing and degradation
errors. Do not compare your readings obtained from sources such as the internet, radio, television or newspapers. The
purpose of your weather station is to measure conditions of your surroundings, which vary significantly from location
to location.
6.10 Factory and Data Export
Press to Enter the Factory Default Mode
Figure 42
Select Setting
Select Setting
Scroll left
Scroll right
Scroll field
up
Scroll field
down
Enter sub-setup
mode
return to
home
1. Re-register Transmitter Indoor. Re-synchronizes the wireless signal from the indoor

Ambient Weather WS-5000 Specifications

General

Wireless Frequency	915 MHz
Wind Speed Accuracy	± 1 mph
UV Index Range	0 to 16
Light Range	0 to 200, 000 Lux
Solar Radiation Range	0 to 1800 W/m²
Connectivity	Wi-Fi
Display Type	TFT LCD
Transmission Distance	1000 feet
Temperature Range	-40 to 140 °F
Humidity Range	10% to 99%
Wind Direction	0° to 360°
Rainfall Measurement	0 to 999.9 inches
Power Source (Outdoor Sensor)	Solar panel with battery backup
Console Power Source	5V DC adapter
Data Storage	Ambient Weather Network
Compatibility	Amazon Alexa, Google Assistant, IFTTT