Ambit U10C034 - Page 43

U10C034 MSO User’s Manual v1.4 June 2008
43
emtaSignalingEndptCtrlDiagTestsStart
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.3.x BITS)
This object is used to start one or more diagnostic tests associated with
a corresponding endpoint. Thus, whenever one or more BITS corresponding
to diagnostic test are set to a value of '1', the MTA will conduct those
tests. Before starting the test, the MTA clears all the BITS of the following
MIBS:
‧ emtaSignalingEndptCtrlDiagTestValid
‧ emtaSignalingEndptCtrlDiagTestResult
‧ emtaSignalingEndptCtrlDiagTestsStop
Once the designated tests are completed the MTA updates the corresponding
BITS in the MIBS:
‧ emtaSignalingEndptCtrlDiagTestValid
‧ emtaSignalingEndptCtrlDiagTestResult
Whenever a test is being run on an endpoint the corresponding 'ifOperStatus'
MIB object is set to a value of 'testing(3)' for the duration of the test.
When the test is completed, the MTA sets ifOperStatus to the value
corresponding to the current state of the line. The selected tests will
not run if the corresponding endpoint is offhook. To force execution of
the selected tests regardless of the endpoint status set the corresponding
startForceTestExecution(11) BIT.
‧ startTipToGroundShortDetection(0)
‧ startRingToGroundShortDetection(1)
‧ startTipToRingShortDetection(2)
‧ startRingerEquivalenceNetwork(3)
‧ startSelfTestNoReboot(4)
‧ startOffHookSimulationTest(5)
‧ startTip1ToRing2Short(6), -- Not currently implemented
‧ startTip2ToRing1Short(7), -- Not currently implemented
‧ startHazardousPotentialsTest(8),
‧ startstartForeignElectromotiveForceTest(9),
‧ startReceiverOffhook(10),
‧ startForceTestExecution(11)
emtaSignalingEndptCtrlDiagTestsStop
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.4.x BITS)
This object is used to stop the test corresponding to the bit being set
if the test is not complete yet by the time when the bit is set.
‧ stopTipToGroundShortDetection(0),
‧ stopRingToGroundShortDetection(1),
‧ stopTipToRingShortDetection(2),
‧ stopRingerEquivalenceNetwork(3),