Ambit U10C034 - Page 44

U10C034 Telephony Version v1.4 June 2008
44
‧ stopSelfTestNoReboot(4),
‧ stopOffHookSimulationTest(5),
‧ stopTip1ToRing2Short(6), -- Not currently implemented
‧ stopTip2ToRing1Short(7), -- Not currently implemented
‧ stopHazardousPotentialsTest(8),
‧ stopForeignElectromotiveForceTest(9),
‧ stopReceiverOffhook(10)
emtaSignalingEndptCtrlDiagTestValid
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.5.x BITS)
This object indicates the validity of the corresponding test case that
was initiated in the emtaSignalingEndptCtrlDiagTestsStart MIB. The
corresponding bit will be set if the test was able to run and the test
result is valid. Clear the corresponding bit if the MTA was not able to
run the test or the test was not initiated or the test was not complete
for any reason and hence, the result is invalid.
emtaSignalingEndptCtrlDiagTestResult(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.
1.6.x BITS)
This object indicates the result of the corresponding test that was
initiated using emtaSignalingEndptCtrlDiagTestsStart MIB. If the
corresponding completed successfully the bit will be set and if the test
failed the bit will be cleared or 0.
‧ stopTipToGroundShortDetection(0),
‧ stopRingToGroundShortDetection(1),
‧ stopTipToRingShortDetection(2),
‧ stopRingerEquivalenceNetwork(3),
‧ stopSelfTestNoReboot(4),
‧ stopOffHookSimulationTest(5),
‧ stopTip1ToRing2Short(6), -- Not currently implemented
‧ stopTip2ToRing1Short(7), -- Not currently implemented
‧ stopHazardousPotentialsTest(8),
‧ stopForeignElectromotiveForceTest(9),
‧ stopReceiverOffhook(10)
emtaSignalingEndptCtrlDiagTestValue
(1.3.6.1.4.1.4413.2.2.2.1.6.4.1.1.7.x OCTET STRING)
This object contains the value which represents the results of the
corresponding test. Each value of the result is represented as a human
readable string indicating the value of the particular parameter used
to evaluate the testing results.
The format of the string containing the results is as follows:
[P=<param>,V=<value>,U=<unit>]
where:
<param> - is the name of the particular parameter evaluated during
the test,
<value> - is the human readable representation of the testing result