U10C034 Telephony Version v1.4 June 2008
46
emtaSignalingAnnouncementCtrl
(1.3.6.1.4.1.4413.2.2.2.1.6.4.2.0 BITS)
This object contains the value controlling the announcements being played
by the MTA in case of service interruption or UPS battery condition. The
service interruptions announcements are required to be played if the phone
is off-hook.
If bit announcementOnRfLoss(0) is set, the MTA MUST play an Announcement
on all endpoints upon the RF loss. Otherwise (the bit is cleared) - the
MTA MUST NOT play the announcement.
If bit announcementOnEndptDisabled(1) is set, the MTA MUST play the
announcement on the end-point which has been disabled by one of the
PacketCable compliant means: ifOperStatus/ifAdmingStatus becomes down(2),
or end-point is not assigned to the particular CMS, or 'pktcMtaDevEnabled'
MIB object is set to false(2). Otherwise - the MTA MUST NOT play the
announcement.
If bit announcementOnEndptDisconnected(2) is set, the MTA MUST play the
announcement on the end-point which becomes NCS disconnected
(pktcNcsEndPntStatusError is in disconnected(3) state). Otherwise - the
MTA MUST NOT play the announcement.
The UPS battery condition announcements are required to be played if the
phone is off-hook and before dial tone.
If bit announcementOnACLoss(3) is set, the MTA MUST play an audible tone
announcement upon detecting the loss of AC Power. The announcements are
required to be played if the phone is off-hook and before dial tone. Otherwise
(the bit is cleared) - the MTA MUST NOT play the announcement.
If bit announcementOnLowBatt(4) is set, the MTA MUST play an audible tone
announcement upon detecting the low battery condition. The announcements
are required to be played if the phone is off-hook and before dial tone.
Otherwise (the bit is cleared) - the MTA MUST NOT play the announcement.
If bit announcementOnBadBatt(5) is set, the MTA MUST play an audible tone
announcement upon detecting the bad battery condition. The announcements
are required to be played if the phone is off-hook and before dial tone.
Otherwise (the bit is cleared) - the MTA MUST NOT play the announcement.
If bit announcementOnBattOverTemp(6) is set, the MTA
MUST play an audible
tone announcement upon detecting the battery over temperature condition.
The announcements are required to be played if the phone is off-hook and
before dial tone. Otherwise (the bit is cleared) - the MTA MUST NOT play
the announcement.
The default value of this object corresponds to the functionality compliant
with the PacketCable requirements - all bits are cleared.
‧ announcementOnRfLoss(0)
‧ announcementOnEndptDisabled(1),
‧ announcementOnEndptDisconnected(2)
‧ announcementOnACLoss(3)
‧ announcementOnLowBatt(4)
‧ announcementOnBadBatt(5)
‧ announcementOnBattOverTemp(6)
To Next Page
Loading...
