H-1.601. 00137-B3.0
Page 31 of 81
in accordance with the following method.
2. Connect the rubber hose of patient value to pressure monitoring port on
the main unit.
3. Connect the pu hose of patient valve to PEEP port on the main unit.
4. Connect breathing hose to the fresh gas intake. Be sure not to bend any
connected air hose.
5. For connection between any other accessories and to the patient, refer
the following Hose Accessories Connection Diagram.
6. In optional configuration of ETCO2 module, connect one end of
mainstream CO2 module to patient and the other end to respiratory
valve of patient and connect ETCO2 data acquisition line to ETCO2
sampling port.
FIGURE 17 Accessories Connection Diagram
1 pressure measuring port 5 Hose
2 PEEP Port 6 patient Valve
3 fresh gas intake (to patient) 7 Mainstream CO2 module
(used in optional
configuration)
4 ETCO2 port 8 simulative lung(patient)
To Next Page
Loading...