H-1.601. 00137-B3.0
Page 52 of 81
6 Sanitization
T5 and its accessories must be sanitized each time after use to keep them in
good condition and avoid cross infection. Each time after sanitation, perform
functional inspection (refer to Section 7 - Functional Inspection).
6.1
T5 Main Unit
Scrub and clean the host simply by soft cloth wet by common water-soluble
sanitizer.
While cleaning, prevent the disinfectant from flowing into the respirator.
Do not clean the surface of machine by organic solvent.
Caution：
Do not fumigate the whole unit with acidum peraceticum or methanal.
6.2
Respiratory Hose Assembly
Any respiratory hose assembly supplied by Amoul shall be sanitized in
accordance with the instructions given below. Any respiratory hose assembly
supplied by another manufacturer shall be sanitized in accordance with such
manufacturer's instructions.
6.3
Components and Accessories
The mask and any other rubber components shall be sanitized with
approved disinfectant.
1. All interior and exterior surfaces of the components shall be adequately
soaked without any air bubble. These components can be sanitized for
the maximum duration as instructed by the disinfectant manufacturer.
2. After disinfection, clean the components with distilled water to prevent
effect of any residual disinfectant on the machine or patient.
3. Place all rubber components in dry air to dry it naturally.
4. Inspect the mask, and make replacement for any damage.
5. Reusable respiratory hose and rubber pads of patient breathing valve
and respiratory mask can be disinfected with high temperature.
To Next Page
Loading...