50
www.amcelettronica.com
KX series v.1.70
zones MenU: lock exclUsion
With this parameter it is possbible prevent the bypass zone when that is open during in the arming.
In the figure above, inputs 1 and 12 (the ones with the square) have been blocked.
Therefore, if they are not ready, the system cannot be armed, it is possible arm only if that 2 zone are ready/closed.
- Select the lock exclusion menu in the MENU, press ENTER
- Use the RIGHT and LEFT arrows to select the desired input, then press ENTER again
- Enable it by pressing CANCEL when the cursor flashes
- Press CANCEL again to delete
- At the end, confirm with ENTER
zones MenU: test enabling
It possible put in test mode the problematic zones (false alarms or other).
In the test status the zone call only a set telephone number (number 8) and disabling the siren, all alarms generated from test zone
are notified in the log, also with the test description.
In the figure above, inputs 1 and 12 (the ones with the square) have been put in test status.
- Select the Enable Test menu parameter. Press ENTER
- Use the RIGHT and LEFT arrows to select the desired input, then press ENTER again
- Enable it by pressing CANCEL when the cursor flashes
- Press CANCEL again to delete
- At the end, confirm with ENTER
zones MenU: keypad bUzzer
With this function it is possible to have an audio signal from keypad buzzer when the linking zone are open.
In the figure above, inputs 1 and 12 (the ones with the square) have been enabled for the buzzer.
- Select the Enable Test menu parameter. Press ENTER
- Use the RIGHT and LEFT arrows to select the desired input, then press ENTER again
- Enable it by pressing CANCEL when the cursor flashes
- Press CANCEL again to delete
- At the end, confirm with ENTER
zones MenU: sirens activation
This parameter determines which sensors should activate the sirens, both external and internal, separately.
2 = internal and external
E = external
I = Internal
- Select SIREN ACTIVATION parameter. Press ENTER
- Use the RIGHT and LEFT arrows to select the desired input, then press ENTER again
- Use the number keys to define the setting
- Press CANCEL again to delete
- At the end, confirm with ENTER
[01] - Input 01
22222IIEE2EE22222
To Next Page
Loading...
Need help?
General