75
www.amcelettronica.com
KX series v.1.70
MENU OTHER PARAMETERS
siren settings: siren duration
This parameter sets the duration time of the siren sound in the event of an alarm.
To set the new value press ENTER to confirm. Can be set (from 0 to 240 sec) press CANCEL to delete the current value
Note: setting 0, the "siren" commands are not activated.
OTHER PARAMETERS: SIREN SETTINGS
siren settings: siren pause
This parameter sets the pause time between one activation and the next in the event of a persistent alarm.
To set the new value press ENTER to confirm. Can be set (from 0 to 240 sec) press CANCEL to delete the current value
Note: by setting 0, there will no longer be a pause between one activation and the next.
siren settings: siren cycles
Siren cycle means the maximum number of siren activations in one 24 hour day (from 00:00 to 23:59).
Ex., 5 cycles of 1 minute means that the siren can ring for 1 minute for a maximum of 5 times in one day. Once the limit assigned
in the case of alarm has been reached, the siren will no longer ring. This stop will be reset at 23:59:59.
To set the new value press ENTER to confirm. Can be set (from 0 to 32 sec) press CANCEL to delete the current value
Note: enter the value 0 to not have ring limits
siren settings: siren to keypad
With this parameter it possible set the keypad for repetition of alarm siren with internal buzzer.
Set 1 for enable, set 0 to disable
siren settings: squawk function
With this parameter it is possible to have a signal from siren when the system is armed and disarmed.
For wireless sirens it is possoble have another info, the memory alarm.
there are 2 menu parameters, 1 for wired sirens, and another for wireless sirens:
SQUAWK
Duration (sec.) 0.0
WIRED SIREN:
WIRELESS SIREN:
SQUAWK
Arm/disarm visual 0
notification with light of arm disarm, switch to 1 for enable.:
notification with sound of arm disarm, switch to 1 for enable.:
alarm notification when disarm panel, the siren will notify with
a low power sound and lamp flashing switch to 1 for enable.: