56
www.amcelettronica.com
KX series v.1.70
WIRELESS MENU 868MHZ FULL DUPLEX (NOT CERTIFIED EN 50131)
The control unit can manage the radio device (sensors, contact, sirens, Etc.) These are programmable in receiver devices EXPRS and
in Kradio. Radio receivers may be enabled in the PERIPHERALS MENU, and are connected on the bus.
The radio receiver can save 56 radio devices divided in different type:
- 32 devices (sensors, contact, smokesensor, etc.)
- 20 Keyfob
- 4 sirens
The radio devices that can be programmed are:
- IF800 (PIR sensor) 1 place in receiver 1 zone in panel used
- CU 800 triple contact (reed, external contact, switch-alarm contact) 1 place in receiver 3 zone can be used in panel
- CM 800 double contact (reed, external contact) 1 place in receiver and 2 zone can be used in panel
- TR 800 keyfob programmable for ON and OFF all partitons and all OUTS
- IF800 T curtain PIR sensor
- SS800 Sismic sensor
- SF 800 smoke sensor
- SRL 800 wireless only battery siren
When the wireless devices are learned to the receiver, is necessary link every device channel to the zone of panel programmed
like wireless, in case of sensors and conatct. For keyfob, after learning, is necessary program the button for specific request of user.
Panel support all zone wireless or mixed wired/wireless in free combinations.
When there is at least an expansion programmed, it is possible use all zone in panel like wireless without wireed expansion.
It is possible use for eg. zone 3 wired(on board) and zone 60 wireless in panel with 64 zones.
It is possible have a full Hybrid system (wireless and wired) without restrctions.
IMPORTANT: before link the wireless device channel to zone, is necessary that the zone is programmed like wire-
less (menu zones --> zones type--> wireless)
To Next Page
Loading...
Need help?
General