To Next Page

To Previous Page

106

4.10.5.7 Pan/Tilt/Zoom

This screen is used to configure Pan/Tilt/Zoom (PTZ) functionality. Below is a screenshot of the PTZ settings screen:

Below is an explanation of the fields on the PTZ settings screen:

• Channel: This dropdown box allows the user to pick which channel they would like to change PTZ settings for.

• Control Mode: This dropdown box allows the user to pick which control move they would like to use for the

specified channel. The two options are Serial and HDCVI.

• Protocol: This dropdown box allows the user to pick a protocol for the specified channel. Default is HDCVI.

• Address: This dropdown box allows the user to pick the corresponding PTZ address for the channel.

• Baud Rate: This dropdown box allows the user to pick a baud rate for the PTZ channel. The options are 1200,

2400, 4800, 9600, 19200, 38400, 57600, or 115200.

• Data Bits: This dropdown box allows the user to pick the amount of data bits for the PTZ transmission. The

options are 5, 6, 7, or 8.

• Stop Bits: This dropdown box allows the user to pick the amount of stop bits for the PTZ transmission. The

options are 1, 1.5, or 2.

• Parity: This dropdown box allows the user to pick the parity for the PTZ transmission. The options are none,

odd or even.

To revert to default settings, click the Default button near the bottom left hand corner. To copy settings to

another channel, click Copy near the bottom left hand corner. To save settings, click the save button near the

bottom right hand corner. To cancel any modifications, click the Cancel button near the bottom right hand corner.

To apply the settings, click the Apply button near the bottom right hand corner.

Amcrest AMDV4M4 User Manual

Questions and Answers: