88
second, the buzzer, tour, PTZ activation, snapshot, record channel functions will begin another 10
seconds while the screen prompt, alarm upload, email will not be activated again. After 10 seconds,
if system detects another alarm signal, it can generate a new alarm since the anti-dither time has
expired.
• Record Channel: This checkbox allows the user to enable the system to record video for that channel when a
motion detection alarm is triggered. Delay is also associated with this tab, it is the This field specifies in
seconds how long the delay between alarm activation and recording should be.
• Sensitivity – Allows the user to set a preset sensitivity setting for motion detected events.
• PTZ Activation: Allows the user to active PTZ functionality to applicable PTZ devices.
• Tour: Allows the user to enable the camera to activate a PTZ tour when a motion detection alarm is
triggered.
• Snapshot: Allows the user to enable the camera to take a snapshot when a motion detection alarm is
triggered.
• Voice Prompts (N/A): Allows the user to customize voice prompts for motion detected events.
• Show Message: This checkbox allows the user to enable the system to show an on-screen message when a
motion detection alarm is triggered.
• Send Email: This checkbox allows the user to enable the system to send an email when a motion detection
alarm is triggered.
• Buzzer: Allows the user to trigger a buzzer once a motion event is detected.
• Log: Allows the user to log all motion detected events that are triggered in the device.
• Alarm Upload: This checkbox allows the user to enable the system to upload alarm information when a
motion detection alarm is triggered.
To revert to default settings, click the Default button near the bottom left hand corner. To copy settings to
another channel, click Copy near the bottom left hand corner. To test a channel’s motion detection, click Test
near the bottom left hand corner. To confirm settings, click the OK button near the bottom right hand corner. To
cancel any modifications, click the Cancel button near the bottom right hand corner. To apply the settings, click
the Apply button near the bottom right hand corner.
4.10.3.5 Abnormality
This screen is used to specify system action in the case of either hard drive abnormality, or network abnormality.
4.10.3.6 HDD
This screen allows the user to specify actions that occur when there is an abnormality with the DVR’s hard disk
drive (HDD). Below is a screenshot of the HDD Abnormality settings screen:
To Next Page
Loading...
