Chapter 2: Installing and Configuring the N8000
Step 2: Establishing Communication with the N8000
Each controller ships with dual IP addresses (192.168.1.99 with a netmask of 255.255.255.0 and 169.254.10.99 with a netmask of
255.255.0.0).
• For the single Ethernet port of the N8001:
The single Eth1 port is assigned both IP addresses.
• For the two Ethernet ports of the N8002/N8012:
Eth0 gets the 192 address and should be used as the outward-facing IP address for LAN or WAN control. The 169 address
(assigned to Eth1) is in the default IP address range with which all N-Series Encoders and Decoders are shipped.
Logging In
The N-Command Controller has a web-based interface. To access the interface, open a web browser and navigate to the unit’s IP
address. Google Chrome is the recommended browser.
• After applying power to the unit, allow approximately one minute for initialization.
• Once the unit boots, enter 192.168.1.99 into your web browser’s URL bar.
• The device log-in page displays. Enter the default username (admin) and password (password). These can be changed
after initial login.
• After successful login, click on the Admin > Unit Management drop-down menu to discover all networked AV devices on
the video network.
• These units display on the Matrix page. The login IP address can be changed by going to Admin > IP Address.
NOTE: The N8000 Software is based in part on the work of the Independent JPEG Group.
NOTE: This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit (http://www.openssl.org/).
FIG. 5
VIEW VIDEO PAGE
NOTE: Screen-by-screen descriptions of the web interface options are provided for your reference in Chapter 3: Configuration
Options on page 11.
These units function as a virtual matrix switch for N-Series Encoders/Decoders and serve as a touch-panel editor for easy graphical
control of networked AV installations.
From any main page in the web interface, you can
access all other main pages by clicking the links in
the top navigation bar.
To Next Page
Loading...
Need help?
General
