Chapter 3: Configuration Options
Video Matrix Page
Click View > Video Matrix to access the page shown in Figure 8. This page displays all discovered devices on your network.
Encoders are listed horizontally across the top of the page while Decoders are listed vertically down the left side. Clicking a unit’s
name takes you to the configuration pages for that device.
Use this page to route video from an Encoder to a Decoder by simply clicking the circle in their common cell on the matrix. If the
two units are not compatible, there will be no circle in that cell. The circle’s color provides you with current connection information.
For example:
White circles signify an active connection.
Gray circles signify that the two units are available for connection (i.e., compatible with each other).
Dark Red circles signify that the two units are compatible with each other, but one of them is offline.
Light Red circles signify that the two units have an active connection, but one of them is offline.
Options are described in Ta ble 3
.
FIG. 8
Viewing Video Equipment
TABLE 3 Video Matrix Page Option Descriptions
Option Description Notes
All Click the circle in the Encoder’s ALL cell to connect all
compatible streams to that Encoder.
This triggers N-Command to send a command to all
compatible Decoders to switch to that one Encoder.
Hide inactive checkbox Enable to hide any discovered units that are currently
not communicating (off-line).
To Next Page
Loading...
